Perel LEDA2001NW-BP Mode D'emploi page 6

5.4 Mounting the lamp
1. This luminaire does not have a built-in device to disconnect it from the
electric mains. Make sure to electrically isolate the luminaire before
installation or maintenance activities are performed.
2. Use the mounting bracket to determine the location of the mounting
holes.
3. Drill the holes and secure the bracket using screws and wall plugs.
4. Connect the power cable to the screw terminal. Make sure there is no
strain on the cable; leave sufficient slack.
Warning: if the power cable is damaged, it must be replaced by the
manufacturer, his service agent, or a similar qualified person in order to
avoid any hazard.
5. To point the lamp in the desired direction: loosen the hinges using a
screwdriver.
6. Tilt the lamp in the desired angle and tighten the hinges.
6. Sensor controls
The sensor controls on top of the PIR sensor are:
 LUX: The device can distinguish between day and night thanks to the
adjustable ambient light setting. The device can work in the daytime
when the "sun" (max.) position is selected with the selector. When set
to "moon", the sensor remains inactive during daylight. To set the
sensitivity level, wait until it gets darker and set the sensitivity you
want.
 TIME: Use the time adjustment control to set how long the floodlight
will stay on after the motion has been detected (5 seconds to
11 minutes).
V. 02 – 16/11/2015
LEDA200xNW-BP
N = neutral, blue
L = line, brown
6 ©Velleman nv