Cleaning And Care - Carrera CRR ICE-21 Mode D'emploi

6. cLeaninG and care

danGer!
remove the wall power supply from the socket before
cleaning the device.
the device, the cable and the wall power supply must
Q
not fall into water or other liquids and must not be rinsed
under running water.
WarninG!
always switch off the device before cleaning it.
Q
do not use any harsh or abrasive cleaning agents.
Q
note:
the device does not require oiling or lubrication
Q
dry cleaning
1. remove the variable attachment
comb from the device.
2. press your thumb on the center of
the shaving unit until it opens and
can be pulled off upwards. do not
drop the shaving unit.
3. clean the shaving unit and the
interior of the device with the
enclosed brush.
4. push the guide of the shaving unit
into the slot and press the shaving
unit onto the device until it stops
with an audible click.
34
Wet cleaning
the shaving unit can be conveniently
cleaned under running, lukewarm water.
the water temperature must not exceed
70 °c.
WarninG! However, the hair trimmer
is not completely waterproof.
1. Before cleaning, make sure that the de-
vice is switched off and not connected
to the mains.
2. press the lift & wash switch (3); the
entire shaving unit extends.
3. Hold the device under running water
so that it can run through the opening.
4. allow the hair trimmer to dry while ly-
ing and opened. it must not be placed
on the charge station.
5. afterwards, push the entire shaving unit
back until it stops with an audible click.
6. clean the housing with a moistened
cloth only.
danGer!
never immerse the entire hair trimmer in water.
replacing the shaving unit
Q Before replacing the shaving unit, make sure that the de-
vice is switched off and not connected to the mains.
Q remove the variable attachment comb from the device.
press your thumb on the center of the shaving unit until it
Q
opens and can be pulled off upwards.
push the guide of the new shaving unit into the slot and
Q
press it onto the device until it stops with an audible click.
35