Charging; Operation - Carrera CRR ICE-21 Mode D'emploi

WarninG! risk of material damage
use the original accessories only.
Q
Q never place the device on hot surfaces (e.g. hob plates)
or near heat sources or open fire.
Q do not cover the wall power supply to prevent overheating.
the shaving unit is a precision part. protect it against
Q
damage.
do not use any harsh or abrasive cleaning agents.
Q

4. charGinG

notes:
Prior to the first use (without cable) as well as for the
Q
ollowing 2-3 charging processes, charge the device for at
least 16 hours.
With regular use the time for a full battery charge is
Q
approx. 10 hours.
in order to ensure long battery life, you should allow the
Q
batteries to completely discharge before recharging it.
please note that the battery capacity will decrease dur-
Q
ing extended periods of storage. For this reason, long
recharging times should be avoided because of the inter-
ruption between the charging and discharging cycles.
30
1. open the charge station and clamp
the connector plug into the designated
space. the cable can now be wrapped
to the desired length (see fig.).
2. Verify that the cable is correctly placed
in the cable outlet and close the charge
station.
WarninG! an improperly placed cable may be jammed and
damaged when closing the charge station. a damaged cable
must be replaced immediately.
3. connect the hair trimmer to the charge station and the
mains adapter to an easily accessible socket. the led
lights up green. it remains lit as long as the device is con-
nected to the mains.
4. after the mains adapter is disconnected, the led switches
off. the run time with fully charged batteries is approx.
45 minutes.

5. oPeration

regardless of the charging state of the batteries, you are
always able to use the hair trimmer with the mains adapter.
1. in order to use the mains adapter, ensure that the device is
switched off.
2. connect the mains adapter to the hair trimmer.
3. connect the mains adapter to an easily accessible socket.
4. use the on/off switch (4) to switch on the device.
replacing / adjusting the variable attachment combs
WarninG! switch off the device before attaching or replacing
the variable attachment combs.
31