Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
push on one of the two variable attachment combs by
Q
carefully inserting the guide arms of the variable attach-
ment comb into the lateral recesses of the device until it
locks into place.
setting the cutting length: use the comb setting switch (8)
Q
located on the rear side of the device for setting the desired
position of the variable attachment comb. the device must
be switched off.
small variable attachment comb (a)
Level
1
Length in mm
2
Large variable attachment comb (B)
Level
1
Length in mm
23
Q
in order to remove the variable attachment
comb, push the comb setting switch (8),
pull out the variable attachment comb com-
pletely and remove it (see fig.).
note: on page 77 you will find the cutting length chart
which you may cut out and laminate, if desired.
place the chart readily available near the hair trimmer.
cutting hair
Q
notes:
Q
the hair to be dressed must be dry.
the cutting length may deviate depending on the cutting
Q
angle.
First, start with a variable attachment comb for a longer
Q
cutting length and then, in the course of the cutting pro-
cess, use shorter cutting lengths step by step.
32
2
3
4
5
6
5
8
11
14
17
2
3
4
5
6
26
29
32
35
38
comb the hair well.
Q
place a sheet or cape around throat and neck to prevent
Q
cut-off hair from dropping into the collar.
start by cutting the hair in the neck or on the sides and cut
Q
towards the centre of the head. then, cut the front section
of the hair towards the centre of the head.
Q
Hold the device such that the flat side of the comb attach-
ment is in contact with the head. move the device evenly
through the hair.
Q
if possible, cut against direction of hair growth.
7
in order to catch all the hair, move the device several
Q
20
times through each section of the hair.
comb the hair repeatedly and well.
Q
thinning hair
7
For thinning your hair, activate the
Q
41
thinning function by moving the slide
switch (2) forward. the toothed thin-
ning comb is now partially covering
the shaving unit (1) (see fig.).
cutting hairlines and beard
Q
use the device without variable attachment comb to cut
hair very short or to cut beard and hairline.
Q
push the switch for the thinning setting to the required
position.
note: please note that these cutting lengths
can only be achieved by holding the device at a
right angle to the surface of the skin.
33
Publicité
Chapitres
Table des Matières
Dépannage
