Publicité
External speaker output
This is provided so that the user can connect the Velocette to an external 16Ω speaker
cabinet, such as a 4 x 12, for a different sound. This is useful for both live and studio use.
When a jack is inserted into this socket the internal 10" speaker is disconnected. Always
ensure that the amplifier is correctly loaded when in use.
Power switch (Off/Standby/On)
As the name implies, this switches the amplifier from OFF to STANDBY mode, where only
the valve heaters are on, to ON for actual use. This should be used correctly every time
the unit is used to prevent problems with valves and increase their life.
Before mains is applied to the unit, check that it is the correct voltage and make sure the
POWER switch is in the OFF position. Connect power lead to mains outlet then switch to
STANDBY and wait at least 30 seconds before switching to ON. This will ensure that the
valves have time to warm up before large voltages are applied to the plates. During short
breaks the amplifier can be switched to standby and will therefore be ready to play when
next needed.
Mains Fuse
In the event of having to replace the mains fuse always use the same rating as marked on
the units rear panel. Using one of higher rating will invalidate the guarantee.
If after replacement the mains fuse should blow a second time, immediately refer the unit
to a TRACE ELLIOT approved service engineer for checking.
TECHNICAL SPECIFICATIONS
INPUTS
TONE CONTROL
CIRCUIT TOPOLOGY
SPEAKER
POWER RATING
1MΩ
SINGLE DUAL FUNCTION PASSIVE CONTROL
PREAMP AND POWER STAGE 100% VALVE
SINGLE 10" CELESTION
~15W
3
Publicité
