HQ Power VDLPROM3 Mode D'emploi page 3

5. Use
Remove the cover of the battery operated mirror ball motor, insert a D-size alkaline battery and close the cover.
Attach the ball + chain to the motor and set the power switch to ON. The mirror ball will start turning at 1.5 RPM.
After connecting the pin spot to the mains, the lamp will be on. By aiming the spot towards the mirror ball, you will
obtain a beautiful, colourful effect.
6. Cleaning and Maintenance
1. All screws should be tightened and free of corrosion.
2. The housing, the lenses, the mounting supports and the installation location should not be deformed, modified or
tampered with e.g. do not drill extra holes in mounting supports, do not change the location of the connections, ...
3. Mechanically moving parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts, apart from the lamp (see "4. Installation" on p.2).
8. Contact your dealer for spare parts if necessary.
9. Check regularly if the key ring or chain shackles have been deformed. If so, demount the mirror ball immediately.
7. Technical Specifications
PAR-36 Pin Spot
Power Supply
Power Consumption
Dimensions
Weight
Lamp
Max. Ambient Temperature
Max. Housing Temperature
Mirror Ball
Diameter
Total Weight
Mirror Ball Motor
Power Supply
Rotation Speed
Maximum diameter of mirror ball
The information in this manual is subject to change without prior notice.
VDLPROM3
max. 230VAC/50-60Hz
max. 30W
∅ 120 x 160mm
1,1kg
PAR-36 lamp [order code LAMP36, LAMP36GE (General Electric)]
45°C
100°C
20 cm (8")
0,9kg
battery, D-type, 1.5V
1.5 RPM
20cm (8")
3 VELLEMAN