Candy CISD 94 Instructions Pour L'installation Et L'utilisation page 3

Les langues disponibles

lamp comes on); when pressing the button a second time (while the pilot lamp is on), the TIMER is activated

and thus the motor stops after 5' (the pilot lamp flashes). Button D: drives the motor in third speed (the

corresponding pilot lamp comes on); when pressing the button a second time (while the pilot lamp is on) , the

TIMER is activated and thus the motor stops after 5' (the pilot lamp flashes). Button E: drives the motor in fourth

speed (the corresponding pilot lamp comes on); when pressing the button a second time (while the pilot lamp

is on) , the TIMER is activated and thus the motor stops after 5' (the pilot lamp flashes).

Pay special attention to the grease filters: if the model purchased has the commands shown in Figure

17: the grease filters must be cleaned approximately once every 30 hours of operation. To remove the filters:

press inward on the clamps at the handles and pull the filter downward. Wash out the filter using a neutral

soap.

If the model purchased has the commands shown in Figure 18: the grease filters must be cleaned approximately

once every 30 hours of operation (when the light button lamp comes on) (Fig.18S). To remove the filters: press

inward on the clamps at the handles and pull the filter downward. Wash out the filter using a neutral soap.

Once the cleaned filters are reinstalled, to reset the counter hold the light button pressed down for about 1"

(Fig.18A) while the corresponding pilot lamp (S) is on. For further information, see the Commands in Fig.18

in the paragraph entitled "Operation".

Replacing the charcoal filters: If the unit is a filtering hood, the charcoal filters must be replaced: to remove

them press inward on the clamp (Fig.19) and rotate the filter downward until the 2 tabs can be removed from

the housing.

If the model purchased has the commands shown in Figure 17, the charcoal filters must be replaced every

120 hours of operation). If the model purchased has the commands shown in Figure 18, the charcoal filters

must be replaced each time the light button (Fig.18S) lamp flashes (i.e. every 120 hours of operation).

Lighting: to remove the halogen lamps, turn the locknut counter-clockwise (Fig.20). Replace with the same

type of lamp.

B4.