OK. ORC 110 Mode D'emploi page 16

EN
CD MODE
Switching on the appliance: Press and hold the
9
indicator lights up.
Set the function switch to the CD position. Power indicator lights up.
Open the CD compartment door and insert a CD with a label facing up.
10
Close the CD compartment door.
11
Note: If no CD is inserted, the display shows
CD PLAYBACK
1. Start or pause playback: Press
12
display.
2. Stop playback: Press . In stop mode, total number of tracks will be shown on the display.
3. Skip to next track: Press
4. Skip to previous track: Press
During playback, press REP repeatedly to switch the playback modes:
13
Press
1x
2x
3x
Note: If no CD is played for more than 10 minutes the appliance will switch itself off automatically.
PROGRAM PLAYBACK
Notes:
• Up to 20 CD tracks can be programmed for a playback in any desired order.
• The program function can be combined with the repeat function.
1. Stop playback: Press .
14
Enter program settings: Press PROG. 01 flashes in the display.
2.
3. Select desired track: Press
Store selected track into the program memory: Press PROG again. Now, 02 flashes in the
4.
display.
5. Repeat step 3 and 4 to program additional tracks.
6. After programming all the desired tracks, press
7. Stop playback: Press 1x .
8. Cancel program playback: Press 1x
AUXILIARY (AUX) PLAYBACK
Switching on the appliance: Press and hold the
15
indicator lights up.
Set the function switch to the AUX position.
Connect auxiliary device to the AUX-IN socket using 3.5 mm jack audio cable (not included).
16
If an auxiliary device is connected, all playback functions of this device need to be used.
IM_ORC110_140605_V03.indb 16
. In pause mode, the play/pause indicator will flash on the
. Press and hold to fast forward.
. Press and hold to fast reverse.
Repeat indicator
Flashes.
Continuously on.
Goes off.
or .
16
/ button for approx. 2 seconds. Power
.
Result
Repeat one track.
Repeat all tracks.
Normal playback.
to start program playback.
again.
/ button for approx. 2 seconds. Power
6/5/14 11:15 AM