Velleman DVBTR Notice D'emploi page 5

6. Remote Control
Battery Installation
Insert the batteries respecting the polarity.
Batteries' Service Life
• The batteries normally last up to one year depending on frequency of usage.
• Replace the batteries when the remote control unit fails to work. Do not mix old and new batteries.
• Use 2 x AAA batteries. Do not use rechargeable (NiCd) batteries.
• Do not short circuit, disassemble, heat or throw the batteries into the fire.
• Do not drop or step onto the remote control.
• Remove the batteries when the remote control is not being used for a long time to avoid electrolytic leakage. Wipe
away any electrolyte leakage inside the remote control. If any leaking should come into contact with parts of your
body, rinse thoroughly with water.
Operation Range
• The operation range is up to 5 meters in angle of 60° of the front of the IR sensor.
• The operating distance may vary according to the room's brightness.
• Do not point bright lights at the remote control sensor.
• Do not place objects between the remote control and the IR sensor. Do not use the remote control while
simultaneously operating the remote control of any other equipment.
7. Installation
Connect this unit and other equipment according to fig. 4 (see "5. Connection").
• Switch on the device via the power switch on the front panel.
• Press the MENU button to enter the MAIN MENU.
• Select a submenu with
select an option and exit the submenu by pressing ENTER.
Shortcut keys:
MUTE: press to mute/un-mute the sound.
TTX: press this button to show the teletext information (if available).
SUB: turn the subtitles on/off by pressing this button.
STANDBY: enter the standby mode, press again to return to working status.
CH+/CH- ( / ): press this button to enter the next or previous menu.
VOL+/VOL- ( / ): adjust the volume level.
OK: press to confirm.
PG+/PG-: press this button to go to the next/previous page.
TV/R: press to switch between TV channels and radio channels.
LAST: return to the last service.
INFO: press this button to show the information of the current service.
MODE: press to browse nine channels at the time.
RED, GREEN, YELLOW, BLUE: function operation.
AUDIO: press to select the audio language or audio output mode.
P-TIMER: press to set the program timer.
HDMI: press to switch between digital and normal AV output.
DVBTR_v2
/ and press OK to enter. Press / to
- 5 - VELLEMAN