Troubleshooting - thomann START 16 Notice D'emploi

• Place the receiver in such a way that is far from a wall and that is at least
1 meter (about 3 feet) above the floor.
• Cell phones, two-way radio equipment or similar devices may disturb
the radio transmission between the transmitter and the receiver, so they
should not be used close to the transmission system.

4 | TROUBLESHOOTING

PROBLEM
No sound or very
low sound level.
Power LED turned off.
Receiver RF LED turned on.
Receiver RF LED turned on.
Transmitter LED turned on.
Batteries status LED is red.
Distortion or unwanted
interferences.
Increasing distortions.
Great intensity difference
when the same source
is via cable, or in case of
connection with other
guitars or microphones.
LEDS SOLUTION
Receiver ON/OFF Make sure the unit is properly
LED turned off. connected.
Make sure the power supply is
properly connected to the receiver.
Raise the volume.
Raise gain on transmitter.
Check the connections between
receiver and amplifier or mixer.
Don't place the receiver close to
metallic objects.
Check that the transmission
space ("visual contact") between
transmitter and receiver is free.
Approached the transmitter to the
receiver.
Make sure the transmitter and
receiver share the same frequency.
Replace batteries.
Remove possible sources of
Receiver RF LED interference such as CD players,
turned on. computers, digital broadcast
sources, etc.
Batteries status
Replace batteries.
LED is red.
Set properly the transmitter gain
selector and the receiver volume.
START 16 Series
| User manual
9