Polaris 480PRO Manuel De L'utilisateur page 9

3. Install the blue restrictor disk in the
UWF to decrease water flow. Or,
install the red restrictor disk to
decrease the water flow even more.
4. Check the wheel RPM. If more than
36 RPM, unscrew the pressure
relief valve to decrease water flow to
the cleaner. Note: The pressure
relief valve should only be adjusted
when a restrictor is installed.
5. If an adjustable valve is installed,
adjust it to reduce the amount of
water flow to the cleaner.
6. Add a sweep hose weight (order
part #B2).
Action: Sweep hose sprays too much water
out of the pool.
Solution: 1. Adjust the speed of the sweep hose
by adjusting the easy-click settings.
2. Replace the sweep hose scrubber if
it is worn or missing.
3. Add a sweep hose weight (order
part #B2) to keep the sweep hose
from spraying.
Action: The cleaner does not clean the
entire pool.
Solution: 1. Verify that feed hose reaches within
6" of the farthest point of the pool.
If not, order a new hose section
from your Polaris dealer.
2. Check thrust jet for straight back
position that optimizes random
turning.
3. While the cleaner is operating, hold
it upside down and look into the
vacuum tube. There should be four
distinct, even jets of water. If there
are not, contact Customer Service
or a Polaris authorized Service
Center for assistance.
Action: The cleaner is running in circles on
its side.
Solution: 1. Check the filter bag, if full it can
weigh the cleaner down on
one side.
2. Check the hose floats to make sure
they are spaced evenly.
Troubleshooting Worksheet
If these solutions do not result in
improved performance, contact the
Polaris dealer who sold you the cleaner
or call Customer Service.
In order to provide faster and more
convenient service, please have the
following information available at the
time of your call or when taking the
Polaris in for service.
1. Serial #:________________________
2. Wheel RPM:__________________
3. Is the back-up valve cycling?
Yes
4. Is the feed hose the proper
length?
Yes
5. Are the swivels rotating freely?
Yes
6. How often do you clean the filter
screen inside the in-line filter?
Never
Twice a Week
7. Are the vacuum jets obstructed?
(While the cleaner is operating, hold it upside
down and look into the vacuum tube. There
should be four distinct, even jets of water.)
Yes
8. Is the drive train functioning?
(As you spin each wheel independently, all
the wheels should spin.)
Yes
www.polarispool.com
No
No
No
Once a Week
Once a Month
No
No