Fusion SG-FT88PWC Instructions D'utilisation page 3

experience. All True-Marine products are supported by the
FUSION 3-year worldwide limited consumer warranty.
Registering Your Waketower Can
Help us better support you by completing our online registration
today.
• Go to www.fusionentertainment.com.
• Keep the original sales receipt, or a photocopy, in a safe
place.
Cleaning the Speakers
NOTE: When mounted correctly, these speakers are rated IP65
for dust and water ingress protection under normal conditions.
They are not designed to withstand high pressure water spray,
which may occur when you wash down your vessel. Failure to
carefully spray-clean the vessel may damage the product and
void the warranty.
Do not use harsh or solvent-based cleaners on the speakers.
Using such cleaners may damage the product and void the
warranty.
1
Clean all salt water and salt residue from the speaker with a
damp cloth soaked in fresh water.
2 Use a mild detergent to remove a heavy buildup of salt or
stains.
Troubleshooting
Before you contact your FUSION dealer or service center, you
should perform a few simple troubleshooting steps to help
diagnose the problem.
If the FUSION speaker has been installed by a professional
installation company, you should contact the company so the
technicians can assess the problem and advise you about
possible solutions.
There is no sound coming from the speakers
• Verify that all connections from the source device and/or the
amplifier are connected correctly to the speaker terminals.
The system lacks bass or high frequencies
• Verify that the correct wire polarity is observed between the
source and speakers.
The wires should be connected positive to positive and
negative to negative.
• Verify that the speakers are attached firmly to the mounting
surface.
The audio is distorted
• Verify that the source volume is not too loud for the speaker,
and reduce the volume if necessary.
• Verify that the panels surrounding the speaker on the vessel
are not rattling.
• Verify that the source device and/or the amplifier are
connected to the speaker terminals correctly.
• If the speaker is connected to an amplifier, verify that the
input level of the amplifier is matched to the output level of
the stereo. For more information, see the manual for the
amplifier.
The LED lights will not turn on
• Verify that all wiring connections are correct and tight.
Specifications
Peak power (watts)
RMS power (watts)
Efficiency (1 W/m)
Installation Instructions
NOTICE
330 W
130 W
91 dB
Frequency response (+3 DB)
Nominal impedance
Recommended amplifier power
(RMS)
LED color options
LED supply voltage
LED load current at 14.4 Vdc
Operating temperature range
Storage temperature range
Compass-safe distance
Tweeter type
Water and dust rating
Dimensions
5
385 mm (15 / in.)
32
1
241 mm (9 / in.)
2
13
224 mm (8 / in.)
16
50 Hz to 20 kHz
4 ohm
From 25 to 250 W, playing music
Blue and white
From 10.8 to 16 Vdc
150 mA
From 0 to 50°C (from 32 to 122°F)
From -20 to 70°C (from -4 to
158°F)
318 cm (10.43 ft.)
Silk dome
IEC 60529 IP65 (Protected
against dust and water ingress.)
3