Dometic WAECO CoolFreeze CDF 16 Notice D'utilisation page 26

Operation
In "HIGH" mode, the battery monitor responds faster than at the levels "LOW"
and "MED" (see the following table).
Battery monitor mode
Switch-off voltage at 12 V
Restartvoltage at 12 V
Switch-off voltage at 24 V
Restart voltage at 24 V
I
NOTE
When the cooler is supplied by the starter battery, select the bat-
tery monitor mode "HIGH". If the cooler is connected to a supply
battery, the battery monitor mode "LOW" will suffice.
➤ Switch on the cooler.
➤ Press the "SET" button three times.
➤ Use the "UP +" and "DOWN -" buttons to select the battery monitor mode.
✓ The selected mode then appears in the display for a few seconds. The
display flashes several times before it returns to the current temperature.
6.5 Using the cooler
A
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the
heat that generated during operation can dissipate. Ensure that
the ventilation slots are not covered. Make sure that the device
is sufficiently far away from walls and other objects so that the
air can circulate.
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated
air can dissipate.
➤ Press the "ON/OFF" button for three seconds.
✓ The "POWER" LED lights up.
✓ The display switches on and shows the current cooling temperature.
✓ The cooler starts cooling the interior.
26
LOW
10,6 V ± 0,3 V 11,4 V ± 0,3 V
11,6 V ± 0,3 V 12,2 V ± 0,3 V
22,0 V ± 0,3 V 24,1 V ± 0,3 V
23,5 V ± 0,3 V 25,3 V ± 0,3 V
CoolFreeze CDF16
MED HIGH
11,8 V ± 0,3 V
12,6 V ± 0,3 V
24,6 V ± 0,3 V
26,2 V ± 0,3 V
EN