Extending The 3D Orchestra System; Subwoofer; Using The Subwoofer For Other Audio Systems; Bass Intensity - Loewe Audiodesign 3D Orchestra 5.1 IS Mode D'emploi

n
3D Orchestra
Instruction manual

Extending the 3D Orchestra system

Subwoofer

Extending the 3D Orchestra system
If you wish to relink your 3D Orchestra speaker and subwoofer again
(e.g. due to an extension or modification of the sound system), the
existing coupling with the Module 3D Orchestra Controller should first
be reset. To do so, press the reset button (R) with a pointed object.
In the 3D Orchestra Speaker, the reset button is in the shaft pole at
the bottom of the speaker. On the 3D Orchestra subwoofer the reset
button is on the panel at the rear side of the subwoofer (see figure in
right column).
The built-in white LED in the 3D Orchestra Speaker flashes slowly after
the reset. This indicates that the speaker is ready for a new coupling.
Rerun the automatic room acoustic measurement as described on
page 21.
R
- 24 -
Using the subwoofer for other audio
systems
Via the RCA jack Line In / Subw the 3D Orchestra Subwoofer can be
used in other audio systems as well. Connect the Line In / Subw jack
via a cinch cable to the Subwoofer/LFE connector of the audio source.
The 3D Orchestra Subwoofer is an active subwoofer. Therefore, it
may only be connected to a preamplifier output of the audio source.
After 10 minutes without an audio signal at the Line In / Subw jack,
the subwoofer will be switched off automatically.
The subwoofer can switch on automatically if interfering signals are
present on the audio lines. In this case, actuate the mains switch
of the subwoofer.
The subwoofer can switch off automatically during longer, very quiet
periods. In this case, increase the volume.

Bass intensity

Using the Bass Intensity controller you can set the basic bass volume
to suit you, when you operate the subwoofer via the RCA socket with
an analogue audio signal.
In the wireless operating mode, this controller has no function.
R