Setting Up / Connecting The Measuring Microphone; Automatic Room Acoustic Measurement - Loewe Audiodesign 3D Orchestra 5.1 IS Mode D'emploi

n
3D Orchestra
Instruction manual

Setting up / connecting the measuring microphone

Automatic room acoustic measurement

Setting up the measuring microphone
Place the measuring microphone between the TV set and the opposite
wall at a distance ratio of 2/3 to 1/3 as shown in the sketch below. The
microphone marked in red must be oriented towards the TV set. The
microphone should be installed at about the level of your listening
position.
Red
labelled
microphone
Connecting the measuring microphone
Plug the 3.5 mm jack at the cable end of the measuring microphone
into the MIC socket on the Module 3D Orchestra Controller.
MIC
2/3
2/3
1/3
1/3
TV set
- 21 -
Automatic room acoustic measurement
For the sound field of the 3D Orchestra sound system to be aligned opti-
mally to your listening position, adjust the unit to your actual room. This
is done using the measuring microphone supplied and an automatic
procedure controlled by the TV set. The following steps are required:
• Measuring the acoustic conditions of the room.
• Optimising the sound distribution.
• Optimising the sound (volume, frequency response, subwoofer
if required).
Switch on the TV set and the 3D Orchestra subwoofer. Make sure
that all 3D Orchestra speakers are connected to the power supply.
Start the automatic room acoustic measurement in the TV System
settings menu.
HOME: Call Home view.
3456 Mark System settings,
OK call System settings.
6 5 Mark Connections,
4 go to next column.
6 5 Mark Sound components,
4 go to next column.
The Sound components wizard menu appears.
... ... Sound com-
ponents
6 5 S elect 3D Orchestra,
OK confirm.
Proceed.
The Select centre speaker menu appears.
...
Sound
components
3 4 Select the desired option for the centre speaker.
TV The speaker integrated in the TV set or the optional
speakers stereo speaker is used as a centre channel.
External An additional 3D Orchestra speaker positioned cen-
speakers trally near the TV is used as a centre channel.
Proceed.
SOUND COMPONENTS WIZARD - Sound playback via ... SOUND COMPONENTS WIZARD - Sound playback via ...
Please specify here via which sound components you want to listen to your TV
sound. If you select a "Speaker system", this must be connected to the DIGITAL
AUDIO LINK socket on the back of the TV set (with an additional adapter if
necessary).
Note: The newly selected parameter must be confirmed with the button.
OK
TV speakers
3D Orchestra
HiFi/AV amplifier
HiFi/AV amplifier or TV speakers (switchable)
Proceed with Cancel with
Select centre speaker Select centre speaker
Specify here the speaker which you wish to use as the centre of your speaker
system.
TV speakers External speakers
Back with Proceed with