Publicité
Les langues disponibles
Les langues disponibles
Operation the ice-making process
1. After all of the water pipe connecting is complet-
ed, plug in the main power supply. Then press "
" button on the control panel to begin the ice
making cycle, and the"Ice"light will be on at same
time. The digit window will display the ambient
temperature normally. The compressor, fan mo-
tor and water pump will run during ice making
process.
2. Each ice making cycle will last about 11 to 30
minutes, depending on the ambient temperature
and the water temperature.
3. When the ice-making process is over the machine
will switch to ice-harvest process. At same time
the system will detect the water level, if the wa-
ter level is lower than required, "Add water"light
starts flashing, open the water inlet valve to sup-
ply extra water to water tank, when the water
supplying process is finished, the "Add water"
light is off again.
Automatic self-cleaning program
Start the self-cleaning program: After connecting
all of the water pipe, plug on the main power supply
EN
NL
plug press the " " button for more than 5 seconds,
this starts the cleaning program. The "Clean" light
will be on during cleaning, the digit window will indi-
cate the left time. The self-cleaning program takes
30 minutes.
Timer Setting
How to set the timer: When the machine is off, press
the "Timer/Clean" button to set the time when the
machine has to turn on. The "Timer" light will go
on, the number in digital window will flash to display
in how many hours the machine will go on. During
the number flashing, press "▲" , "▼" button to add
or remove hours, the default setting is zero. Five
seconds after setting, your desired setting will be
programmed.
10
10
4. When the "Full " indicator is on, the unit stops
running. If you remove enough cubes, the unit will
start to work again after a 3 minute period.
5. During the ice-making process, press the "▲"
or "▼" button to adjust the ice-making process
duration period length, this will change the thick-
ness of the ice cube. The default setting is zero,
1 minute will add or decrease to the process per
pressing of the "▲" or "▼" button. 5 seconds after
the last press, the new setting are programmed.
6. Bad water quality will cause bad quality of ice
cubes and will reduce the transparency of the ice
cube.
NOTE: Created ice cubes are joined together and
still need to be broken apart.
Cancel the self-cleaning program: It takes about
30 minutes to complete one self-cleaning program.
When the program is over, the system will be in off-
state automatically. And also you can press the " "
button on control panel to cancel the self-cleaning
program by force.
How to cancel the ON-Timer: Press the "Timer/Tim-
er" button, the number in digital window will flash to
display the present delay time of your ON-Timer, and
press the button again to cancel the setting. Press-
ing the " " button will also cancel the timer.
How to cancel the OFF-Timer: This is the same pro-
cedure as for canceling the ON-Timer.
Publicité
