Beta 1895 6 Mode D'emploi page 10

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
• Always use the following personal protective equipment:
• safety shoes
• eye protection
• protective workwear
• protective gloves against physical agents
• During use the cleaner gets overheated. Do not touch the interior of the cleaner with your bare hands
at this stage.
• Do not operate the power supply cable or the controls of the cleaner with damp or wet hands.
• Use the cleaner in well-aired, dry rooms.
• Do not inhale any harmful gases that may be released during the cleaning operations.
• Before replacing the cleaner, make sure that it has cooled to room temperature.
CLEANER SAFETY
• Periodically check that the cleaner and the power supply cable are free from defects.
• Do not use the cleaner if damaged, because electric shocks may occur.
• Do not modify the cleaner. This can reduce the effectiveness of safety measures and increase
operator risk.
• Connect the power supply cable to the mains socket, checking that the mains voltage matches the
voltage stated on the plate of the cleaner. (See TECHNICAL DATA table)
• Do not cover the cleaner while using it. Allow for an adequate amount of space for ventilation.
• Unplug the cleaner when not in use.
• Do not use the cleaner in humid or wet environments; do not expose it to rain. Wet and contaminated
environments increase the risk of electric shocks.
.
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING CLEANER
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS USE PROTECTIVE GLOVES AGAINST PHYSICAL AGENTS WHILE
OPERATING DEVICE
ALWAYS WEAR EYE PROTECTION
ALWAYS WEAR SAFETY SHOES
ALWAYS WEAR PROTECTIVE CLOTHING
Additional personal protective equipment to wear according to the values found in the
environmental hygiene/risk analysis survey if the values exceed the limits under current
regulations.
10
EN I