Disassembling The Parts - CombiSteel 7065.0005 Mode D'emploi

Disassembling the parts

Removal of the tap
The tap should be cleaned regularly to prevent
bacteria formation and to get rid of food waste
accumulation.
Figure 1
As shown in the picture, press the sides of the tap
from both sides and pull it upwards, the tap will come
out of its place.
Re-assembly: Press the plunger of the tap into the tap
channel in the bowl as shown in the picture and press
it down until it clicks.
Figure 2
Cleaning And Sterilizing Parts
All dis-assembled parts must be cleaned and
sterilized.
It should be done as follows:
1. Fill a container with hot water and detergent (50-
60°C).
2. Wash all parts with detergent.
3. Rinse with hot water and make sure that there is
no food residue left.
4. Rinse all parts with water and clean with a dry
cloth.
5. Leave the pieces to dry in a clean place.
Recommended Daily Cleaning
Make sure to turn off the machine and empty the
bowl through the tap. Remove the bowl cover. Hold
the tank as shown in the illustration and lift the front
side up.
After pulling out the front of the bowl, pull the bowl
towards you.
Turn the nut clockwise.
www.combisteel.com
Figure 3
Figure 4
Figure 5
5