Troubleshooting - CombiSteel 7065.0005 Mode D'emploi

Troubleshooting

PROBLEM
The dispenser is not
working
The tap constantly drips
The beverage is flowing
from different points of
the machine.
White helix mixer does not
turn
The dispenser does not
produce granita
White helix mixer is
making high noise while
turning
CAUSE
1- The master key is in position "0"
2- The dispenser may not be
connected to the electricity
1- Tap gasket is not properly fitted.
2- Tap spring is not properly fitted.
1- The bowl is not properly fitted in
place.
2- The bowl and the gasket are not
properly lubricated with Vaseline.
3 - The gasket is damaged
1- The key is in position "0"
2- The metal tower is covered with ice
preventing the helix to turn.
1- C is in position (I)
2- The dispenser has been placed near
a heat emitting machine
3 -Insufficient air flow
4- The condenser is dirty
5- Density is not properly adjusted
1- The nut holding the white helix
mixer may not be properly installed.
2- The front gasket is not properly
lubricated.
3- The metal tower is covered with ice
www.combisteel.com
SOLUTION
1- Bring main switch to position "1"
2- Connect the dispenser to the
electricity.
1- Check if the gasket is properly fitted
2- Fit the spring properly in place.
1- Fit the bowl in place as shown in this
manual.
2- Lubricate the bowl and the gasket
3- Replace the gasket with a new one
1- Bring switch to position "I"
2- Turn off the cooling and wait for the
ice to melt, Do not use hot water.
1- Change C to (II)
2- Change the place where the
dispenser has been installed.
3- Make sure there is enough air flow
by securing 15cm on each side of the
dispenser
4- Clean the condenser
5- Adjust density with the switch
1- Make sure the nut is properly
installed
2- Lubricate the gasket
3- Turn off the cooling and wait for the
ice to melt, Do not use hot water.
10