Installation; Preheating - all-clad TG806 Guide De L'utilisateur

• Clean the plates using a dishwasher agent and a non-abrasive sponge.
• The grill is made up of two independent removable plates (b) that can be used either separately or together.
When you install the plates, make sure that they are well placed. It is indispensable that both plates are installed
on the appliance, even if you only intend to use one.
• Install the removable splash guard (a).
• To get the drip tray(h) in the Use position, pull it about 1cm until it is aligned with the front surface of the
appliance (to be done once, while unpacking the product: the drip tray has to be released as it was pushed inside
the product to be protected).
• Unwind the cord completely.
• Do not touch the metallic parts of the appliance while it is being preheated or used because they are very hot.
• Make sure the thermostats (g) are in the mini position (on the
outlet.
• The red light (located in the center) (d) will turn on and remain on to indicate that the cord is plugged in.
• Preheat the grill(s) fixing the thermostat controller(s) (g) in the maximum position until the green LED
indicator lights turn-on. Then adjust to the desired cooking temperature.
• You are now ready to begin cooking.
• The green lights will blink regularly while the appliance is in use to indicate that the temperature is being
maintained.

INSTALLATION

PREHEATING

position) and then plug the cord to a wall
•
EN
9