CTC CLATRONIC KA 2701 Mode D'emploi & Garantie page 25

5....-05-KA 2701 DK
• Insert the plug in a duly installed 230V/50Hz protective contact socket. The
details can be found on the appliance's nameplate.
• Make sure that the appliance is switched off (The light in the on/off switch is
off).
1. Open the water tank lid.
2. Now fill with enough fresh cold water for the desired number of cups.
You can read the level on the water level display. Do not overfill the appliance
(max. 10 cups).
3. Close the water tank lid.
4. Swing the filter the left. As your machine has a permanent nylon filter, you can
fill the coffee powder directly into the nylon filter (approx. 1 teaspoon for 2 cups).
Lock in the filter until it snaps into place.
5. Place the pot evenly on the base. Please ensure that the lid is on the pot.
6. Switch on the appliance (the LED in the switch lights up).
7. The brewing lasts about 10 to 15 minutes.
8. Your appliance is provided with a drip stop. By removing the pot, before the
water runs through the filter completely, it avoids that the coffee drips on the
base. If there is still water in the tank or filter, make sure that the pot is placed
back under the filter to avoid overflowing.
9. When the coffee stops flowing into the filter, you can remove the pot.
10. Switch off the appliance (the LED in the switch is off).
11. If you would like to keep the remaining coffee warm, the switch must remain in
the "EIN/1" position. The hot plate will keep the coffee warm until you switch the
machine "AUS/0".
De-scaling is necessary when the brewing time increases substantially. Use only
commercially available citrus acid-based de-scaler. Follow the recommended
instructions for use.
1. Always pull he plug before cleaning and wait for the appliance to cool down.
2. Clean the outside of the appliance, if necessary, with a slightly moist cloth with-
out any detergent.
3. The filter holder can be washed as usual in warm washing up water.
4. Do not immerse the pot in water. Wipe the outside with a moist cloth. You can
clean the inside with warm water. If necessary, use a soft brush.
10.12.2002 12:06 Uhr
Electrical connection
Operating
De-scaling
Cleaning
Seite 25
GB
25