Important Charging Notes; Storage Recommendations - DeWalt DCBL720 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

operation, flashing the red light with two fast blinks followed by a pause.
This indicates the power source is out of limits.

Important Charging notes

1. Longest life and best performance can be obtained if the battery
pack is charged when the air temperature is between 65  °F and
75  °F (18  ° – 24  °C). DO NOT charge the battery pack in an air
temperature below +40 °F (+4.5 °C), or above +105 °F (+40.5 °C).
This is important and will prevent serious damage to the battery pack.
2. The charger and battery pack may become warm to the touch
while charging. This is a normal condition, and does not indicate
a problem. To facilitate the cooling of the battery pack after use,
avoid placing the charger or battery pack in a warm environment
such as in a metal shed or an uninsulated trailer.
3. A cold battery pack will charge at about half the rate of a warm
battery pack. The battery pack will charge at that slower rate
throughout the entire charging cycle and will not return to
maximum charge rate even if the battery pack warms.
4. If the battery pack does not charge properly:
a. Check operation of receptacle by plugging in a lamp or other
appliance;
b. Check to see if receptacle is connected to a light switch which
turns power off when you turn out the lights;
c. Move the charger and battery pack to a location where the
surrounding air temperature is approximately 65  °F – 75  °F
(18 ° – 24 °C);
d. If charging problems persist, take the tool, battery pack and
charger to your local service center.
5. The battery pack should be recharged when it fails to produce
sufficient power on jobs which were easily done previously. DO
NOT CONTINUE to use under these conditions. Follow the
charging procedure. You may also charge a partially used pack
whenever you desire with no adverse effect on the battery pack.
6. Foreign materials of a conductive nature such as, but not limited
to, grinding dust, metal chips, steel wool, aluminum foil, or any
buildup of metallic particles should be kept away from charger
cavities. Always unplug the charger from the power supply when
there is no battery pack in the cavity. Unplug the charger before
attempting to clean.
7. Do not freeze or immerse the charger in water or any other liquid.
WARNING:
get inside the charger. Electric shock may result.
WARNING:
pack in any liquid or allow any liquid to enter the battery pack. Never
attempt to open the battery pack for any reason. If the plastic housing of
the battery pack breaks or cracks, return to a service center for recycling.

Storage Recommendations

1. The best storage place is one that is cool and dry, away from direct
sunlight and excess heat or cold.
2. For long storage, it is recommended to store a fully charged battery
pack in a cool dry place out of the charger for optimal results.
note: Battery packs should not be stored completely depleted of
charge. The battery pack will need to be recharged before use.
SAVE THESE InSTRuCTIOnS
7
Shock hazard. Don't allow any liquid to
Burn hazard. Do not submerge the battery

Publicité

Table des Matières
loading

Table des Matières