Publicité
Les langues disponibles
Les langues disponibles
2
CONTROL SETUP (Yellow LED ON)
To enter Control Setup mode, press the Up and Down keys simultaneously for more than
three seconds. The same key action exits this mode. The parameters are as follows:
June 1997
1/32-DIN Temperature Controller
Operator's Manual
Setpoint (1) value
Setpoint 2 value
Proportional
Band value
Reset (Integral) value
Rate (Derivative)
Bias (Manual Reset)
ON/OFF
Hysteresis value
Alarm 1 value
Alarm 2 value
Input Filter Time Constant value
Input Offset value
Output Cycle Time value
Setpoint Lock
Disable/enable access to Alarm Value in
Normal Operation mode
Page 4
Scroll key steps through
displays; Up/Down keys adjust
displayed values.
Appears only if Dual Setpoint
operation is configured.
Appear only if Manual
Tuning and PID Control
are configured.
Appears only if ON/OFF
Control is configured.
Appears only if two alarms are
configured.
OM076
Publicité
