WEST N2300 Manuel De L'opérateur page 2

1
NORMAL OPERATION (Yellow LED OFF)
In this mode, the display normally shows the process variable value. Use the Scroll key to
step through a sequence of parameters as follows:
The following parameters are available in Normal Operation:
June 1997
1/32-DIN Temperature Controller
Operator's Manual
Scroll key steps through displays; Up/Down keys adjust displayed values.
Process Variable
Alarm Status
Setpoint Selection
Setpoint (1)
Setpoint 2
Alarm (1) value
Alarm 2 value
Not adjustable
Included only if two alarms configured
and if either or both is (are) active.
Included only if Dual Setpoint configured
Adjustable only if enabled (see Section 2)
Included only if Dual Setpoint configured;
adjustable only if enabled (see Section 2)
Included only if enabled (see Section 2)
and an alarm is configured
Included only if enabled (see Section 2)
and two alarms are configured
Page 2 OM076