Publicité
Les langues disponibles
Les langues disponibles
Check that there are no fuel leaks
from the engine, tank or fuel lines.
Check the starter and starter cord.
Clean the outside of the spark plug.
Remove it and check the electrode gap.
Adjust the gap to 0.6-0.7mm or replace
the spark plug. Check that the spark
plug is fitted with a spark plug cap.
Clean the machine's cooling system.
Clean the outside of the carburetor
and the space around it.
Clean the fuel tank.
Check all cables and connections.
Check the clutch, clutch springs and
the clutch drum for wear. Replace if
necessary by an authorized service
workshop.
Check the clutch, clutch springs and
the clutch drum for wear. Replace if
necessary by an authorized service
workshop.
To reduce the fire hazard, clean dirt,
leaves and surplus lubricant, etc from
the muffler and engine.
Check the blade.
(1) If operated in dusty areas carry out maintenance more frequently.
(2) A specialist technician should carry out this maintenance if the owner does not have
the appropriate tools or mechanical knowledge.
X
X
X
X
X
X
X
X
X
X
X
1. Do not spray the unit with water. Ingress of water may damage the engine and
electrical connection.
2. Clean the unit with a cloth, hand brush, etc.
Maintenance schedule
12 hours of use
Air filter
clean
Spark plug
check
Engine oil
check
Expert inspection is required:
a) If the lawn mower strikes an object.
b) If the motor stops suddenly
c) If the blade is bent (do not align!)
d) If the gears are damaged.
Replacing and resharpening the mowing blade at the end of the mowing season always
resharpen the mowing blade or, if required, replace the mowing blade with a new one.
Always have the mowing blade resharpened or replaced by a customer service center
(measurement of imbalance).
Unbalanced blades will cause the lawn mower to vibrate violently-risk of accident！
Change the blade
Caution: do not touch rotating blade
WARNING! Before removing or refitting the blade, ensure that the engine is
switched off and the spark plug cap is disconnected and moved away from the spark
plug.
To remove the blade, grip the end of the blade using a thickly padded glove or rag.
Use a socket wrench or ring spanner to remove the bolt, washer and blade. (Fig.12)
Replace a new or re-sharpened blade and tighten the bolt.
Fig.12
94|
95
24 hours of use
36 hours of use
clean
replace
clean
replace
replace
check
GB
Publicité
