Publicité
Les langues disponibles
Les langues disponibles
RZ 2610015858 02-12:RZ 2610015858 02-12.qxp 2/9/12 2:29 PM Page 4
tool to your right. If the workpiece is between
the tool and your body, then feed the tool to
your left. Feeding the tool in the wrong
direction causes the cutting edge of the bit to
climb out of the work and pull the tool in the
direction of this feed.
Never use dull or damaged bits. Sharp bits
must be handled with care. Damaged bits
can snap during use. Dull bits require more
force to push the tool, possibly causing the bit
to break.
Never touch the bit during or immediately
after the use. After use the bit is too hot to be
touched by bare hands.
Never lay the tool down until the motor has
come to a complete standstill. The spinning
bit can grab the surface and pull the tool out of
your control.
Never use bits that have a cutting diameter
greater than the opening in the base.
Do not use the tool for drilling purposes.
This tool is not intended to be used with drill
bits.
Always use the tool with the depth guide
securely attached and positioned flat
against material being cut. The guide
securely positioned on the material improves
the stability and control of your tool.
When connecting tool to dust collection
and extraction systems, be sure these are
connected and used according to tool and
vacuum instructions. Proper use of dust
collection can reduce dust related hazards.
When using tool with dust collection and
extraction systems, empty the dust
GFCI and personal protection devices like
electrician's rubber gloves and footwear will
further enhance your personal safety.
Do not use AC only rated tools with a DC
power supply. While the tool may appear to
work, the electrical components of the AC
rated tool are likely to fail and create a hazard
to the operator.
Keep handles dry, clean and free from oil
and grease. Slippery hands cannot safely
control the power tool.
container
frequently during work, after completion of
work, and before storing the tool. Be
extremely careful of dust disposal, materials in
fine particle form may be explosive.
Do not throw dust on an open fire. Fine
dust particles may burn explosively.
When performing sanding and surface
preparation operations with tool connected
to a dust collection and extraction system
be aware of the materials creating the dust.
Combustion from mixture of varnishes,
lacquers, polyurethane, oil or water with dust
particles can occur if there is a static
discharge, electric spark, or excessive heat
causing a fire in the dust collection and
extraction system.
Do not use dust extraction for operations
that include burning, smoking or
smoldering items like hot ashes or sparks.
Fire inside the vacuum tank or bag may occur.
Dust may smolder and set vacuum on fire
long after work is completed.
Do not use dust extraction with explosive
dusts, varnish, polyurethane coatings,
cleaners, or oil-based paints.
motors create sparks which may ignite the
dust or fumes.
Do not use dust extraction when working
on metal.
cutting metal may be hot and may spark which
may melt plastic adaptors, vacuum hoses, and
may cause a fire inside the vacuum tank or
bag.
Additional Safety Warnings
Develop a periodic maintenance schedule
for your tool. When cleaning a tool be
careful not to disassemble any portion of
the tool since internal wires may be
misplaced or pinched or safety guard return
springs may be improperly mounted.
Certain cleaning agents such as gasoline,
carbon tetrachloride, ammonia, etc. may
damage plastic parts.
Risk of injury to user. The power cord must only
be serviced by a Rotozip Factory Service
Center or Authorized Rotozip Service Station.
-4-
before
beginning
Swarf from sanding, grinding or
work,
Electric
Publicité
