Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.4 Variable installation possibilities: Overlying
installation
Dimensions in mm
4
R5
2
min.50
1
Bracket
•
Insert the hob and align it.
•
From the bottom, insert the brackets with screws in
the holes provided for fastening the brackets, align the
brackets and screw them tight.
Tighten the screws with a hand screw driver only; do
not use a battery-operated screw driver.
•
In the case of thin worktops make sure that the bra-
ckets are correctly positioned.
Minimum distance to adjacent walls
Opening dimensions
Cutout dimensions
Outer dimensions of the hob
Important:
There is a risk of breakage if the hob is canted or sub-
jected to stress during installation!
84 x 455
44
Instructions for assembly
4
800
750+1
2 4
1
min.50
7.5 Variable installation possibilities: Flush ins-
tallation
3
R7
2
min.50
1
Glue the sealing tape onto the corner of the supporting
edge of the worktop so that no silicone adhesive can be
pressed under the hob.
Place the hob into the worktop cut-out without any adhesi-
ve and align it. Use shims if necessary
Fill the gap between the hob and the worktop with heat-re-
sistant silicone adhesive.
Important
Silicone adhesive must not get under the support surface.
If this occurs it will not be possible to remove the hob again
at a later stage. No liability will be assumed in the case of
failure to observe these instructions.
3
84 x 455
804+1
3
750+1
2
min.50
1
GB
3
Publicité
Chapitres
Table des Matières
