PCM GSC-816 Mode D'emploi page 2

English
1. To fix the tool holder to the machine,
introduce the shank and use the pin for the
positioning.
Then tighten the 4 screws of fixations
(Important, make sure that the screws have
the same strength of tightening).
2. Adjust the offsets of 2 positions.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
GSC-816
3. During the mounting or the dismounting of
your tools, block the broach on flats
planned for that purpose,
supplied.
4. The tool shank diameter should never
NOTE :
Never use the tool holder with empty
positions. Use the supplied protection plug.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation:
22.11.2013
using a spanner
have a difference of more than 0.4 mm
compared to the clamping diameter of
collet
Example: clamping diameter 9.5 mm
=> Shank diameter 9.1 mm minimum.
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
Document:
Mode d'emploi
GSC-816
Page: 2 de 4
office@pcm.ch