Sunjoy Hillgard Guide De L'utilisateur page 5

Hardware Pack 2
Part
BB
EE
FF
Fig. 5: Secure the slanted beam (F) to the assembled post with flat washers (BB) and nuts (FF).
Fig. 6: Insert the top end of the slanted beam into the top connector (I), then assemble the hook (K) to the top
connector.
Fig. 7: Insert the top end of the middle beam (D) into the top connector (I).
Fig. 8: Secure the middle beam (D) to the connector (E) with bolts (EE), flat washers (BB) and nuts (FF).
Fig. 9: Insert the small slanted beam (H) into the small connector (J).
Fig. 10: Install the canopy (O) without unfolding it fully. Insert the small slanted beam (H) into the slanted
beam (F).
Description
M6 Flat washer
M6 x 35 Bolt
M6 Nut
Quantity
16 PCS
8 PCS
8 PCS
Image