Plates; Dimensions; Location - Foster SOLO PLUS Notice De Mode D'emploi Et D'entretien

6 Installation

6.1 Plates

The unit is supplied with warning and attention plates as listed in the relevant table.

6.2 Dimensions

A B
SP1/SP2 357 250
SP3/SP4 390 250
SP5 427 250

6.3 Location

C D E
719 340 122
809 360 122
929 410 122
To obtain optimal operation of the unit act as follows:
A) Place the unit in a well ventilated room, far from heat sources.
B) Limit the number of door openings.
C) Make sure that the unit has good air supply and discharge.
D) Fit a drain line to the defrost water drain connection in the lower part of the unit.
Note: Solo units are equipped with automatic evaporation of defrost water; drain is just
a precaution in case of troubles.
Solution 1
Inject silicone on the whole
conveyor perimeter
F G H
28 332 506
28 332 540
98 452 645
Solution 2
Condensate drain
line D. 10
I L M
60 620 545
60 820 745
60 820 745
X Y
337 550
337 750
456 750
6