INTERTECHNO ITF-100 Mode D'emploi page 29

GB
Available as a handheld or wall-mounted transmitter.
Individual switching:
The wireless scene switch can be used for all types of intertechno
self-learning wireless receivers.
For switching on and off lights, dimming lights, operating blinds and
garage doors etc...
1 random code out of 67 million possible codes guarantees a high level
of security.
Scene switching: (Fig. 1)
Multiple wireless receivers can be changed to the desired switching state
with the touch of a single button.
3 scenes can be selected.
Wireless receivers with storage are required for scene
switching!
Coding: Teaching in wireless receivers (Fig. 2)
To adjust the encoding, please also read the operating instructions of
your self-learning wireless receiver.
Place the wireless scene transmitter near the wireless receiver.
1.) Open the transmitter by sliding the mounting plate to the side.
2.) Remove the battery safety strips.
3.) Move the slider to position 1.
4.) Put the wireless receiver in learn mode.
5.) By pressing the transmitter once, the ON signal is transmitted (the
LED will light up green) and the wireless receiver takes over the
encoding.
One more receiver can be taught in.
Now one or more wireless receivers can be switched on by pressing a
button. The LED will light up green when ON.
By pressing a second time, the off signal will be transmitted and the LED
will light up red 2x.
If using a radio dimmer, press and hold the transmitter until the desired
brightness has been reached.
The LED will flash green during this process.
How to erase codes
To erase the encoding, proceed as described above in 3.) to 5.),
but now the off signal is transmitted by pressing twice.
Operating instructions
ITF-100
3
›