DURAVIT SensoWash i Lite Notice D'utilisation page 34

Problem
No water spray from
the spray wand.
Flushing Function
Product does not
flush.
EN
Auto flush does not
work.
Heated seat
Seat heating does not
work.
Seat temperature is
too warm / cold.
Seat temperature is
too cold
30
Potential cause
The spray nozzle is
clogged.
Seat sensor has lost
contact.
The time between two
flushes is too short.
The stop valve is closed.
Power or water supply
failure.
Auto flush deactivated.
Seat sensor is dirty or wet. > Clean the surface.
User was not seated
while using toilet.
User sat on seat for less
than 6 sec.
Seat heating is switched
off.
Product is in energy saving
mode (orange LED).
Solution
> Clean the spray
nozzle.
> Sit down and select
the function again.
This is normal. Water
takes approx. 25 sec. to
refill.
> Open the stop valve.
> Pour a bucket of
water 8 l (2 gal.) into
the toilet.
> Add more water if
the water level is too
low.
> Contact
help@duravit.com.
> Activate Auto-Flush.
> Auto flush only
works when the user
is seated.
> Sit on the seat for
more than 6 sec.
> Activate seat
heating.
> Adjust seat heating
temperature.
This is normal.
> Switch off energy
saving mode to heat
seat.
Ch.
7.1
1.5
App
7.1
6
App
6
App
6
App