Havit PJ202 Manuel De L'utilisateur page 16

For Android System
1. Turn on the projector, select Screen Mirroring as the input source to enter the
interface of Screen Mirroring.
2. Go to the settings of your mobile device, find Developer options and turn on the
USB debugging.
Tip:
The steps turn on Developer options vary from different models of Android device. You
may check it from internet or contact us for the detailed steps. We take Samsung Galaxy
S8+ as an example.
Go to settings of your Android device, then tap About phone > Software
•
information > Build number.
Continuously tap on Build number for several times until it shows Developer
•
mode had been turned on.
Get back to the settings of your mobile device, it will show Developer options.
•
3. Connect your Android mobile device to the USB port of the projector with the
ORIGINAL USB cable.
4. Tap OK when your Android mobile device pops out the window of Allow USB
debugging? Then the display of your Android mobile device will be mirrored to
the wall/screen after a while.
Allow USB debugging?
USB debugging is intended for development
purposes only. Use it to copy data between your
computer and your device, install apps on your
device without notifications, and read logo data.
Notes:
1. The USB cable MUST be the ORIGINAL cable or the cable which can transfer data,
otherwise screen mirroring may fail. You can plug the cable into your laptop to
check the availability of transferring data.
2. Some mobile devices may not support screen mirroring due to the compatibility.
3. Some Android mobile devices may only transfer the display without audio due to
the protocol restrictions.
Cancel
OK
16