AudioSonic RD-1540 Mode D'emploi page 4

BEFORE USE
• Take the appliance and accessories out the box. Remove the stickers,
protective foil or plastic from the device.
• Connect the power cable to the socket.
Note: Make sure the voltage which is indicated on the device matches
the local voltage before connecting the device. Voltage: 220V-240V~ 50Hz.
USE
• Turn the volume control switch (6) and adjust the volume.
• Slide the AM/FM/AUX switch (3) to the desired band (AM /FM).
• Search for the preferred station by turning the tuner (5).
• Slide the volume switch (6) to off position after you finished listening.
Comments
• MW-band uses an internal directional antenna. Turn the radio in the right direction
for a good reception.
• Make sure the FM-antenna (2) is fully extended for a good FM-reception.
AUX-IN
• To connect an external device on the radio, you can use the line-in cable (9).
• Put the line-in cable (9) in the designated Aux-in jack on the external device.
• Turn on the external device and adjust the volume with the volume switch (6).
4
Instruction manual
SPECIFICATIONS
Model no.: RD-1540
FM-frequency: 88 – 108 MHz
AM-frequency: 540 – 1600 KHz
Speakers: 5 W
AC supply: 230V~ 50Hz
Power output: 3,5 W
Dimension: 22,5 x 12,5 x 14 cm