Jotul F 480 Série Manuel D'installation page 15

Fig. 23
4. If it is just the gasket that goes against the front of the burn
chamber that needs to be replaced (A) the gasket groove
can be cleaned and a new gasket can be glued into place.
5. If replacing a glass gasket or glass, unscrew the closing
mechanism that is attached with screws and washers (B)
6. Remove the glass holders (C) that are attached with 4
screws (D .
7. Lift out the glass.
Fig. 24
8. Thoroughly clean the gasket groove and glue new gaskets
into place: The glass gasket (A), door gasket (B) and the
gasket under the glass (C). Make sure the door gaskets t
right into the corners (D).
Fig. 25
9. Place the glass holders on a soft material with the side, as
illustrated (A), turned up.
10. Apply a bead of glue into the gasket groove (B) which is
now facing up.
11. Fit the gasket (C) into the groove with the ends sticking out
as illustrated (11 cm on one side).
Fig. 26
12. Turn the glass holders and apply a bead of glue into the
gasket grooves. Note the overlap (A)
13. When re tting, follow the same procedure in reverse order.
Remember to place a washer under the hinge.
ENGLISH
15