Korg TM-60 Manuel D'utilisation page 5

3.
Tune the instrument using the reference tone and meter.
4.
If the SOUND/SOUND BACK button is pressed again, you will
return to the Meter mode.
Setting the tempo and time signature
1.
Press the METRONOME ON button.
"
2.
Press the TEMPO
Press and hold the TEMPO
for 1 second to switch between Pendulum Step (pendulum
of a mechanical metronome) and Full Step. If Pendulum Step
is selected, " " will appear on the display.
After selecting "PENDULUM STEP" or "FULL STEP", press the
TEMPO
membered even when the power is off.
If you've selected "PENDULUM STEP"
Pressing the TEMPO
the tempo by 1 step. The value will change continuously if
you hold down the button.
30 µ 32 µ 34 ... 88 µ 92 µ 96 ... 232 µ 240 µ 252 µ 30 ...
If you've selected "FULL STEP"
Pressing the TEMPO
the tempo through the range of 30–252 in steps of one. The
value will change continuously if you hold down the button.
3.
Press the START/STOP button to start the metronome.
The metronome pendulum will swing from left to right ac-
cording to the tempo and the TAP TEMPO button will blink
according to the tempo also.
4.
If you want to change the time signature, press the BEAT
or buttons to make your selection.
The time signature will change as follows.
... µ 0 µ 1 ... 9 (9 beats) µ
center beat) µ
center beat) µ
5.
Play along with the metronome tempo.
6.
To stop the metronome, press the START/STOP button.
Using tap tempo
The tap tempo that you input will be displayed as a BPM (Beats
Per Minute) value.
1.
Press the METRONOME ON button.
"
2.
Press the TAP TEMPO button several times at regular inter-
vals at the tempo that you want.
The TM-60/TM-60C detects the interval used when pressing
the button and displays it as a BPM (Beats Per Minute) value,
and it will be set as the tempo.
While the tempo is detected, " " will appear on the display.
When the BPM that has been detected by the tap tempo is
less than 30, "Lo" will appear on the display and the tempo
will be set at "30. "
If the BPM detected by the tap tempo exceeds 252, "Hi" will
appear on the display and the tempo will be set at "252. "
3.
Press the START/STOP button to start the metronome.
The metronome pendulum will swing from left to right ac-
cording to the tempo and the TAP TEMPO button will blink
accordingly.
The tap tempo can also be input while the metronome is in
use.
4.
Play according to the tempo.
5.
To stop the metronome, press the START/STOP button.
Using the metronome
" will appear on the display.
or
, buttons to set the tempo. This setting is re-
(Quadruplet) µ
(Triplet) µ
" will appear on the display.
button to set the tempo.
and
or button will increase or decrease
or button will increase or decrease
(Quadruplet without the
(Duplet) µ 0 ...
buttons simultaneously
(Triplet without the