Korg TM-60 Manuel D'utilisation page 4

The closest note to the input sound will appear in the center
of the display. Tune your instrument to the correct pitch, so
that the desired note name appears.
If you're using the internal mic, place your instrument as
close as possible to the mic so that extraneous sound is not
picked up while tuning.
5.
While playing a single note on your instrument, tune it so
that the meter indication is at " " at the center and the
green indicator in the center of the tuning guide lights up.
The red indicator on the left side of the tuning guide will
light up if the pitch of your instrument is flat, and the red
indicator on the right side will light up if the pitch is sharp.
Tuning to a just major third above or a minor third above
If you want to tune to a just major third above A (0 cent),
tune your instrument so that the note name indicator dis-
plays C# and the meter indication is at " " on the left side.
If you want to tune to a just minor third above A (0 cent),
tune your instrument so that the note name indicator dis-
plays C and the meter indication is at " " on the right side.
Tuning using the tone (Sound Out mode)
1.
Press the TUNER ON button.
You will enter the Meter mode.
2.
Press the SOUND/SOUND BACK button to select Sound Out
mode.
The reference tone is output from the
or speakers. Use the volume control to adjust the output
volume.
3.
Press the CALIB·NOTE
The output reference tone changes as follows.
C (C3) µ C ♯ µ D µ E ♭ µ E µ F µ F ♯ µ G µ G ♯ µ A µ B ♭ µ B µ
C (C4) ... C (C6) µ C (C3)...
This setting is stored even when the power is off.
4.
Tune the instrument according to the reference tone.
If connected to either the INPUT jack or the
jack (or both), the Meter mode will start simultaneously and
you can tune your instrument while viewing the meter.
5.
If the SOUND/SOUND BACK button is pressed again, output
of the reference tone stops, and the device returns to Meter
mode.
Tuning using the tone and meter
(Sound Back mode)
In Sound Back mode, the tone of the input instrument is detect-
ed, and the closest reference tone is output. This can be used to
check the pitch deviation of the tone that you output.
This function can be used when you are connected to either the
INPUT jack or the
1.
Press the TUNER ON button.
You will enter the Meter mode.
2.
Hold down the SOUND/SOUND BACK button to enter Sound
Back mode.
"
control to adjust the volume.
If headphones are connected to the
the input sound from the internal mic or INPUT jack will be
received and the reference tone will be output from the
headphones.
If nothing is connected to the
put sound from the INPUT jack is received and the reference
tone is output from the speakers.
If both the
connected, the Sound Back mode will not function.
or
(headphones) jack (or both).
" will appear on the display. Use the volume
(headphones) jack and the INPUT jack are not
(headphones) jack
button to select the note.
(headphones) jack,
(headphones) jack, the in-
(headphones)