Replacing The Light Bulbs - GE ESS25LSQASS Manuel D'utilisation Et D'installation

Replacing the light bulbs.

Setting either or both controls to 0 does not remove power to the light circuit.
Tabs
Refrigerator Compartment—Upper Light
Unplug the refrigerator.
The bulbs are located at the top of the
compartment, inside the light shield.
Remove the screw at the front of the
light shield.
To remove the light shield, press in on
the tabs on the sides of the shield and
slide forward and out.
Refrigerator Compartment—Lower Light
This light is located above the top drawer.
Unplug the refrigerator.
Lift the light shield up and pull it out.
Freezer Compartment
Unplug the refrigerator.
Remove the shelf just above the light
shield. (The shelf will be easier to
remove if it is emptied first.) Remove
the screw at the top of the light shield.
To remove the light shield, press in on
the sides, and lift up and out.
Dispenser
Unplug the refrigerator.
The bulb is located on the dispenser
under the control panel.
Remove the light bulb by turning
it counterclockwise.
www.GEAppliances.com
After replacing the bulb with an
appliance bulb of the same or lower
wattage, replace the light shield and
screw. When replacing the light shield,
make sure that the tabs at the back of
the shield fit into the slots at the back
of the light shield housing.
Plug the refrigerator back in.
After replacing the bulb with an
appliance bulb of the same or lower
wattage, replace the shield.
Plug the refrigerator back in.
Replace the bulb with an appliance
bulb of the same or lower wattage,
and reinstall the light shield. When
reinstalling the light shield, make
sure the top tabs snap securely
into place. Replace the screw.
Reinstall the shelf and plug the
refrigerator back in.
Replace the bulb with a bulb of the
same size and wattage.
Plug the refrigerator back in.
15