Publicité
Les langues disponibles
Les langues disponibles
■
Never pick up or carry the product while it
is running.
■
Stop the mower motor, remove the isolator
key (DC mode only), disconnect the
product from the power supply, and make
sure that all moving parts have come to a
complete stop for the following cases:
●
whenever
you
unattended (including disposal of grass
clippings).
●
before cleaning a blockage or unclogging
discharge chute
●
before checking, cleaning or working on
the product
●
after striking a foreign object; inspect the
product for damage and make repairs
as necessary before restarting and
operating the product.
●
before removing the grass box or
opening the grass discharge chute
cover.
●
If the product starts to vibrate abnormally
(check immediately)
–
inspect for damage, particularly the
blades
–
replace or repair any damaged parts
–
check for and tighten any loose parts
■
Avoid holes, ruts, bumps, rocks, property
stakes, or other hidden objects. Uneven
terrain could cause a slip and fall accident.
ADDITIONAL BATTERY SAFETY
WARNINGS
WARNING
To reduce the risk of fi re, personal injury,
and product damage due to a short circuit,
never immerse your tool, battery pack or
charger in fl uid or allow a fl uid to fl ow inside
them. Corrosive or conductive fl uids, such
as seawater, certain industrial chemicals,
and bleach or bleach-containing products,
etc., can cause a short circuit.
OVERLOAD PROTECTION DEVICE
The product has an overload protection
device. When overloading is detected, the
product will automatically switch off.
If the product stops working, release all handle
bar switches for a few seconds in battery
4
| English
leave
the
product
mode of operation or let motor cool down for a
few minutes in AC mode of operation. Follow
normal switch on procedure to activate the
mower again. The motor should again start
working.
This applies to both AC and Battery mode of
operation.
If the protection device operates often, raise
the height of the cut, check the blade is not
damaged. If it still occurs, bring the product to
an authorised service centre for investigation.
RESIDUAL RISKS
Even when the product is used as prescribed,
it is still impossible to completely eliminate
certain residual risk factors. The following
hazards may arise in use and the operator
should pay special attention to avoid the
following:
■
injury caused by vibration
●
Always use the right tool for the job. Use
designated handles and restrict working
time and exposure.
■
injury caused by noise
●
Exposure to noise can cause hearing
injury. Wear ear protection and limit
exposure.
■
injury from contact with the blades
■
injury caused by thrown objects
TRANSPORTATION AND STORAGE
■
Stop the product, remove the isolator key
and the battery pack or disconnect from the
power supply. Make sure that all moving
parts have come to a complete stop. Allow
the product to cool down before storing or
transporting.
■
Clean all foreign material from the product.
Store it in a cool, dry, and well-ventilated
place that is inaccessible to children. Keep
away from corrosive agents such as garden
chemicals and de-icing salts. Do not store
outdoors.
■
For transportation, secure the product
against movement or falling to prevent
injury to persons or damage to the product.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local
and national provisions and regulations.
Publicité
