Danby DWC057A1BSS Manuel Du Propriétaire page 7

OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time it must be allowed to remain upright
for 6 hours before plugging in to avoid damage to
internal components.
1. Remove the two screws that secure the right
hinge axis to the lower right hinge. Slide the
door outward from the bottom to remove it from
the upper right hinge.
2. Remove the upper right hinge from the cabinet.
3. Remove the screw hole covers from the upper
left side of the cabinet and install the upper left
hinge. Place the screw hole covers in the screw
holes on the upper right side of the cabinet.
4. Remove the hinge hole cover from the upper left
side of the door and place it in the hinge hole on
the upper right side of the door. Install the door
on the upper left hinge.
5. Slide the bottom of the door toward the unit to
line it up with the lower left hinge. Install the left
hinge axis to secure the door to the lower left
hinge.
6. Loosen the screw on the side of the handle using
the provided hexagon spanner. Remove the
handle. Install the handle on the right side of the
door using the same screws.
Note: Before tightening the screws to secure the
hinge axis, ensure that the top of the door is level
with the top of the cabinet, that the actuator on the
bottom of the door is making contact with the switch
on the cabinet and that the rubber gasket is making
a good seal with the cabinet all the way around.
1. Lower right hinge
2. Axis screws
3. Right hinge axis
4. Actuator
5. Upper right hinge
6. Hinge screws
7. Upper left hinge
8. Lower left hinge
9. Left hinge axis
1
1
2
3
7
4
5
4
6
6
2
3
4
5
6
6
7
2 8
9