Using The Appliance; Cleaning And Care - SilverCrest SSM 200 A1 Mode D'emploi

Using the appliance

1) Take the fruits out of the freezer about 10–
20 minutes before use.
2) Place a suitable bowl under the outlet
3) Remove the pusher
4) Add the prepared fruits into the feed tube
5) Switch on the appliance using the on/off
switch (position I).
6) Applying light pressure, use the pusher
push the fruit into the appliance. The chopped
fruit will come out of the outlet
time. If the pusher
down, remove it and add a little more fruit or
ingredients.
NOTE
► If you want to make a sorbet from several
different fruits/ingredients, add the different
fruits alternately into the feed tube
way, the fruits will be mixed directly.
7) Once all the fruits are chopped, stop the appli-
ance by moving the on/off switch
position.
8) Remove the power plug from the socket.
9) Unscrew the end cap
roller carefully out of the roller housing
10) Use a knife to scrape any remaining fruit
residue from between the blades on the blade
roller and add this to the bowl.
11) Mix the fruit in the bowl.
You can now serve the sorbet.
■ 6 │ GB │ IE │ NI
.
from the feed tube
to
after a short
cannot be pressed further
. In this
to the O
and pull the blade

Cleaning and care

RISK OF ELECTRIC SHOCK
► Always remove the plug from the mains power
socket before you clean the appliance.
.
.
Ensure you never submerse the motor unit
in liquid, and never allow liquid to enter the
motor unit housing
WARNING! RISK OF INJURY!
► Take great care when handling the blade
roller .
♦ Clean the motor unit
every use . If there is heavy soiling, add mild
detergent to the cloth. Rinse detergent residues
off with clear water. Ensure that there are no
detergent residues on the appliance, and that the
appliance is completely dry before renewed use.
♦ Remove the pusher lid
cleaning purposes.
♦ Wash the pusher
blade roller
housing in lukewarm water with a little
detergent.
.
♦ Ensure that all parts are completely dry before
re-use.
NOTE
► The blade roller
end cap
cleaned in a dishwasher.
Place the parts, where possible, in the upper
basket and ensure that none of the parts can
get stuck. Otherwise they could get bent or
otherwise deformed.
.
with a moist cloth after
from the pusher
, the pusher lid
, the end cap and the roller
, pusher , pusher lid
, and the roller housing
SSM 200 A1
for
, the
,
can be