Recline, Tilt & Lift Operation; Joystick Retractable Mount - Zippie ZM-310 Mode D'emploi

Z I PP IE Z M- 310
R. RECLINE, TILT & LIFT OPERATION
The recline, tilt and lift features on your chair can all be operated using the joystick on
your chair. Follow the instructions below to operate:
1. Make sure your controller is on.
2. From the Drive Mode, press the Mode button (A) to enter Power Seating Mode.
3. Move the joystick left or right selecting the power option (recline, tilt, lift, legrests)
you wish to control.
4. Move the joystick forward or backward to adjust the selected power option to the
desired position.
5. Press the Mode button to return to normal operation or continue moving the joy-
stick left or right to adjust the next power option. Multiple Mode button presses
will be necessary if other modules, or Output, are active.
20
Mating Connectors
To connect the communication cables: Holding the connector housing, firmly push the
connector into its mate until you can no longer see the yellow plastic. The connectors are
secured using a friction system.
To disconnect the communication cables: Holding the connector housing firmly, pull the
connectors apart.
NOTE– Do not hold or pull on the cable. Always grip the connector when connecting and discon-
necting.
When the control system is first switched on after a connection, or system component
change, the timer will be displayed while the system checks itself. Then the re-start icon
will be displayed. Switch the control system off and on again to operate,
S. JOYSTICK RETRACTABLE MOUNT (Optional)
The joystick or Enhanced Display is mounted with a mechanism which allows the control
to be locked in a forward or retracted position using magnets.
Adjustment
a. To retract the joystick, push outward on the inside of joystick.
b. Push the joystick away from front of armrest until it locks into retracted position.
c. To return to forward position, push the joystick forward until it locks into place.
127899 Rev. A
19
21
20
VIII. USE AND MAINTENANCE
21