Electrical Connection; Instructions For Use; Operation - Profi Cook PC-DKI 1035 Mode D'emploi

Do not use the following types of pots :
Pots with Pots with a base
bended (con- diameter of less
vex/parabolic) than 12 cm.
bases.

Electrical Connection

Connected load/wattage
It is recommended to use a separate connection
protected over a 16 A safety switch.
CAUTION: Overload!
Do not use extension cables or multiple sockets
as the power consumption of this device is too
high for these.
Connection
• Before inserting the mains plug into the socket
check whether the voltage which you intend to
use corresponds to that of the machine. Please
see the label on the machine for details.
• Only connect the machine to a correctly
installed safety socket.

Instructions for use

Power rating of the left hob:
Power rating of the right hob:
• The two hobs work independently of one
another.
• If you want to heat up your food in a hurry, use
the right hob.
The following description applies to both hobs:
• The appliance has a fine sensor. A light touch
of the control panel with the finger is sufficient.
Use the finger, not the tip of the finger.
• Each registered touch is confirmed by a beep.
• In the event that the appliance does not react
Pots standing
when you press the buttons, clean the control
on feet.
panel with a soft, dry cloth. Even a thin film of
water can make the operation difficult.
• Ensure that the control panel is always clean
and dry and that it is not covered by objects of
any kind.
Standby mode
After you have connected the device's plug to
the mains supply, the hub is in standby mode. A
signal will sound. The display will show "L" for
"LOW" (low temperature).
• Put a suitable pot on the cooking zone.
• Press the
cooking. The message "L" will go out. The
indicator lights HEAT and TEMP. will flash. The
indicator light above the
button will light up.
Select Temperature or Power As Function
max. 1400 W
• Press the
max. 1900 W
one of the 10 temperature settings.
• Press the
one of the 10 power ranges.
Select Temperature or Power For The Cooking
Plate
• Select a temperature between 60°C and
240°C, or a power range between 1 and
10 with the

Operation

ON/STANDBY button (5), to start
NOTE:
You now have to press a function button
within 30 seconds, otherwise the cooking
plate will switch back to STANDBY mode.
TEMP button if you want to select
HEAT button, if you want to select
or the button.
NOTE:
• The cooking plate always starts on temper-
ature 120°C or power level 5 respectively.
ON/STANDBY
53