Jonsered LM2148CMD Manuel De L'utilisateur page 12

Battery Replacement
1. The battery is located underneath a cover behind
the engine.
2. Stop the lawnmower and disconnect the spark
plug.
3. Remove the screws from the cover.
4. Remove cover to gain access to the battery.
IMPORTANT:-Replacement batteries will need to
be charged before use.
Ensure that neither the charger nor the battery
are exposed to moisture
The battery pack can be replaced by unclipping
the battery from its housing and disconnecting
the battery pack from the battery leads.
General Guidance on Rechargeable Battery
1. Charging time is 24 hours.
2. Under normal usage the battery will be charged
during the running of the engine.
3. To keep in prime condition the battery should be
charged at least once every six months.
4. Exceeding the charging period may shorten the
battery life.
5. Protect electric cable. Never carry the battery
charger by the electric cable only.
6. If after an extended usage period the battery
quickly runs down after a full 24 hour charging
period, a replacement battery is probably needed.
7. Do not attempt to open the main body casing.
8. Clean only with a dry soft cloth.
9. Never use a damp cloth or flammable liquids such
as petrol, white spirits, thinners etc.
10. Dispose of old batteries safely.
The engine brake cable should always be
adjusted to stop the engine within 3 sec.
CAUTION! For adjustment contact your
authorized service dealer.
At the End of the Mowing Season
1. Replace blade, bolts, nuts or screws, if necessary.
2. Clean your lawnmower thoroughly.
3. Ask your local Service Centre to clean the air filter
thoroughly and carry out any service or repairs
required.
4. Drain engine of oil and petrol.
Storing your Lawnmower
1. Do not store your lawnmower immediately after
use.
2. Wait until the engine has cooled to avoid a
potential fire hazard.
3. Clean your lawnmower
4. Store in a cool, dry place where your lawnmower
is protected from damage.
Service Recommendations
Your product is uniquely identified by a silver and
black product rating label.
We strongly recommend that your product is
serviced at least every twelve months, more often
in a professional application.
Engine Maintenance Schedule
Follow the hourly or calendar intervals, whichever
occur first. More frequent service is required when
operating in adverse conditions
First 5 hours - Change oil.
Every 5 hours or daily - Check oil lever. Clean
finger guard. Clean around muffler.
ENGLISH - 5
Maintenance
Every 25 hours or every season - Change oil if
operating under heavy load or high ambient
temperature. Service air cleaner.
Every 50 hours or every season - Change oil.
Inspect spark arrester, if equipped.
Every 100 hours or every season - Clean cooling
system*. Replace spark plug.
* Clean more often under dusty conditions, or
when airborne debris is present or after
prolonged operation cutting tall, dry grass.
Engine Servicing & Guarantee
The engine fitted to your lawnmower is
guaranteed by the Engine Manufacturer. To
obtain further information contact your dealer.
Fault Finding Hints
Engine Will Not Start
1. Ensure OPC Lever is in the start position.
2. Check that the control lever is in the '+' position
3. Check that there is sufficient fuel in the tank and
the cap air vent is clear.
4. Remove and dry the spark plug.
5. Petrol may be stale, replace. Once petrol has
been replaced, it may take a little time for fresh
petrol to filter through.
6. Check that the blade bolt is tight. A loose bolt
could cause difficult starting.
7. If the engine will still not start, immediately
disconnect the spark plug lead.
8. CONSULT YOUR LOCAL APPROVED SERVICE
CENTRE.
Engine Will Not Turn Over (LM2148CMDE only)
1. Ensure OPC Lever is in the start position.
2. Battery flat - start your lawnmower manually.
3. If the engine will still not turn over,
immediately disconnect the spark plug lead.
4. CONSULT YOUR LOCAL APPROVED SERVICE
CENTRE.
Lack of Engine Power and/or Overheating
1. Check that the control lever is in the 'normal'
position.
2. Disconnect the spark plug lead and allow the
engine to cool down.
3. Clean grass clippings and debris from around the
engine and air inlets and the underside of the
deck including the chute.
4. Clean the engine air filter (Ask your local
Approved Service Centre to clean the engine air
filter thoroughly).
5. Petrol may be stale, replace. Once petrol has
been replaced, it may take a little time for fresh
petrol to filter through.
6. If the engine still lacks power and/or is
overheating, immediately disconnect the spark
plug lead.
7. CONSULT YOUR LOCAL APPROVED SERVICE
CENTRE.
Excessive Vibration
1. Disconnect the spark plug lead.
2. Check that the blade is correctly fitted.
3. If the blade is damaged or worn replace it with a
new one.
4. If vibration persists, immediately disconnect
the spark plug lead.
5. CONSULT YOUR LOCAL APPROVED SERVICE
CENTRE.