Operation; For Low Pressure Inflation - Inflation Of Items That Require Less Than 20 Psi; For Standard Tire Inflation - Inflation Of Tires Between 20 Psi And 99 Psi - Campbell Hausfeld RP3300 Instructions D'utilisation

Operation

For use with 12-volt DC power outlets rated 15 amps or higher. Do not
use with older 8 amp cigarette lighter receptacles.
FoR low PRessuRe InFlAtIon -
InFlAtIon oF IteMs thAt RequIRe less thAn 20 PsI
1a . If inflating a low pressure tire, attach universal adapter to valve stem with the
locking lever in the open/up position . Be sure to press the universal adapter onto
the valve stem thread completely . Failure to do so could lead to loss of tire pressure
during this process .
b . If inflating a sports ball, insert a metal inflation needle into the universal adapter .
Make sure the needle is secure in the adapter .
2 . When the universal adapter is firmly in place, press the locking lever down . (See
Figures 3 and 4) .
3 . Plug the power cord into a power socket .
4 . Turn pressure selector dial to the "LO" setting (LO setting is just below 20 psi
setting) . (See Figure 5) .
5 . Press power button . (See Figure 6) .
6 . When item reaches desired firmness, press power button again to stop inflation .
The actual pressure will then read on digital gauge . (See Figure 7) .
7 . If more inflation is needed, repeat steps 5 and 6 .
Overinflation can be dangerous.
Pay attention while inflating low pressure items
FoR stAnDARD tIRe InFlAtIon -
InFlAtIon oF tIRes Between 20 PsI AnD 99 PsI
1 . Attach universal adapter to valve stem with the locking lever in the open/up
position . Be sure to press the universal adapter onto the valve stem thread
completely . Failure to do so could lead to loss of tire pressure during this process .
2 . When the universal adapter is firmly in place, press the locking lever down . (See
Figure 4) .
3 . Plug the power cord into a power socket .
4 . Turn the pressure selector dial until desired pressure is reached . (See Figure 5) .
5 . Press power button . (See Figure 6) . Unit will turn off automatically when set
pressure is reached .
to prevent overinflation.
Universal
Adapter
Figure 3 - lock universal Adapter securely
Universal
Adapter
Figure  - lock universal Adapter securely
Figure 5 - Pressure selector Dial
Figure 6 - Power Button
Current
Pressure
Figure 7 - Digital Pressure gauge
www.chpower.com
RP3300
loCk
Metal
Needle
loCk
Valve
Stem
Preset
Pressure
Selection
5