IKEA FIXA Mode D'emploi page 10

DECLARATION OF CONFORMITY
We declare under our sole responsibility
that this product, FIXA Hammer drill
Li-Ion 14.4 V, is in conformity with the
following standards or standardized
documents: EN 60745-1, EN 60745-2-6,
EN 55014-1, EN 55014-2, EN 61000-3-2, EN
61000-3-3, EN 60335-1, EN 60335-2-29, EN
62233 in accordance with the provisions of
the directives 2006/42/EC, 2004/108/EC,
2006/95/EC, 2002/96/EC, 2002/95/EC.
Technical documentation at: IKEA of
Sweden AB, Box 702, Tulpanvägen 8,
SE-343 81 Älmhult, SWEDEN.
The undersigned is responsible for
compilation of the technical documentation
and makes this declaration on behalf of
IKEA of Sweden AB.
Christina Niemelä Ström
Business Area Manager
IKEA of Sweden AB
ASSEMBLY
Before any work on the machine
(e. g., maintenance, tool change,
etc.) as well as during transport
and storage, set the rota tional
direction switch to the centre posi-
tion. Unintentional actuation of the On/Off
switch can lead to injuries.
Battery charging
Charging your hammer drill/driver
When the charger is connected to the
electricity supply, the red diode on the
hammer drill lights up. The diode lights up
while the battery is being charged (13).
Under normal conditions of use the
hammer drill can be recharged several
hundred times.
ATTENTION! The recharging process
generates heat in the battery.
Note: The battery that is supplied with
the hammer drill has been charged for test
purposes only and must be fully recharged
before use.
First read the safety instructions and then
follow the loading instructions. Insert the
charge connector into the socket (13)
in the hammer drill. Then connect the
charger's transformer (16) to the electricity
supply.
Make sure that there are no knots or sharp
bends in the cable.
The charger's transformer and the battery
have been designed to be used together.
NEVER use this charger to recharge
cordless tools or batteries from other
manufacturers. The battery will gradually
lose its charge over a period of time, even
if the tool is not used.
The lithium-ion battery is protected against
deep discharging by the "Electronic Cell
Protec tion (ECP)". When the battery is
empty, the ma chine is switched off by
means of a protective circuit: The inserted
tool no longer rotates.
9