Scope Of Delivery; Explanation Of Symbols - Conrad REELY SKY Apollo DLG Notice D'emploi



4. Scope of Delivery

1 Left and right wings
2 Fuselage with canopy
3 Elevator unit
4 Rudder unit
5 Small parts (servo shaft covers, screws, etc.)
Operating instruction (not displayed)
In the further course of these instructions, figures in the text always refer to the adjacent figure or the figures within the section. References to other
figures are indicated with the corresponding figure number.
The following components not included in delivery are required for assembly and operation:
Assembly:
Soldering gun, servo extension cable, shrink hose (inner diameter approx. 2.5 mm), hot-air gun, cutter knife, miniature drill with different drill inserts, screwdriver,
superglue, sandpaper, hook-and-loop tape and double-sided adhesive tape.
Attention!
Observe the safety information of the respective manufacturer when using glues and work with glues in well-ventilated rooms only.
Operation:
Flying requires a suitable remote control system with at least 4 channels and micro receivers, 4 servos of the 9 g-category and a receiver battery with a small
build. Depending on remote control and installation site of the receiver, you may need an additional Y-cable to connect the two aileron servos and/or two servo
extension cables (approx. 25 cm long)
The model "Apollo" is not a beginner's model.
Due to its size and the basic concept or purpose, there are increased demands to the receiver system. When purchasing the remote control
components, observe that the transmitter is programmable (computer transmitter) and that the receiver system (receiver and servo) is as small and
light-weight as possible.


5. Explanation of Symbols

The symbol with the exclamation mark points out particular dangers associated with handling, function or operation.
The "arrow" symbol indicates special advice and operating information.
16
Figure 1