Cleaning And Maintenance - Soba HF310 Mode D'emploi

HF310 COFFEE MAKER

CLEANING AND MAINTENANCE

Don't forget to always disconnect the plug and allow the appliance to cool
before cleaning or maintenance!
Cleaning
• Never use aggressive or abrasive cleaners!
• Never immerse the appliance in water!
• Wipe the outer surfaces with a damp cloth.
• Raise the filter unit lid, lift a little, tilt to the side and remove.
• Clean the filter unit as well as the glass jug with lid thoroughly in warm soapy
water. Dry well and replace. These parts and the water tank lid are dishwasher
proof and may be cleaned in the dishwasher.
Descaling
Furring deposits that would impair the functioning of the appliance may form in time.
Descale the coffee maker regularly to remove these using a proprietary descaling
agent for coffee machines and following the maker's instructions.
• Take care that none of the descaling agent comes into contact with the keep-
warm plate..
• Fill the water with fresh cold water up to the 12 marking (Max.) together with the
recommended amount of descaling agent.
• Place a paper filter in the filter unit to catch any particles that are flushed out.
Close the filter unit and place the glass jug on the keep-warm plate.
• Do not switch on. Leave the appliance to stand for at least 30 minutes but no
longer than an hour to allow the descaling agent to work.
• Start the coffee making cycle.
• As soon as the cycle is finished, remove the glass jug and discard the solvent.
Do not pour the discarded solution into an enameled sink. Do not use the same
solution a second time.
• Repeat the process if necessary.
• Traces of the descaling agent can spoil the taste of the coffee. Consequently,
the coffee maker must be rinsed thoroughly by letting fresh water run through
several times until every trace of the descaling agent has been eliminated.
• To finish, thoroughly clean the glass jug and filter unit.
Subject to change without prior notice.
5
INSTRUCTION MANUAL