Soba HF310 Mode D'emploi page 3

HF310 COFFEE MAKER
KNOWING YOUR NEW COFFEE MAKER
1. Water tank lid
2. Water tank
3. Water level indicator
4. On/Off switch
5. Keep-warm plate
6. Filter unit lid
7. Filter unit with anti-drip protection
8. Plug
9. Glass jug with lid
STARTING UP
Choose a suitable place to set up your coffee maker; it should be heat resistant, flat
and not slippery and in the immediate vicinity of a contact protected socket.
Before using for the first time
To remove any impurities or manufacturing residues, let fresh water run through the
coffee maker several times until the water collected in the jug is clear and clean.
Proceed as follows:
• Raise the water tank lid (1)
• Fill the water tank (2) with cold fresh tap water up to gauge 12 (Max.) on the
water level indicator (3).
• Close the water tank lid (1), place the glass jug (9) with lid in place, on the keep-
warm plate (5) and close the filter unit (7) (without using a filter paper).
• IMPORTANT: When making coffee the glass jug must never be put under the filter
unit without its lid as otherwise the non-drip valve on the filter unit will remain
closed and the filter would run over.
• Connect the coffee maker and switch on.
• Empty the glass jug.
• Wait about 5 minutes before refilling with fresh water so the appliance can cool
down
3
INSTRUCTION MANUAL