Soba HF310 Mode D'emploi page 4

HF310 COFFEE MAKER
Cleaning the parts of your coffee maker
Later, when you have rinsed the appliance through thoroughly, clean the individual
pieces.
• Disconnect the mains plug (8)
• Wait till the appliance has cooled completely.
• Remove the glass jug.
• Raise the filter unit lid, lift the filter unit a little, tilt slightly to the side and
remove.
• Wash the filter unit and glass jug in warm soapy water. These parts are
dishwasher proof and can also be cleaned in the dish washer.
• Dry the parts well and reassemble.
When the filter coffee maker has not been used for sometime clean it in the same
way .
Making coffee
• Fill the water tank with sufficient fresh cold water for the number of cups wanted
(at least 2 maximum 12 cups).
• Raise the filter unit lid and insert a standard coffee filter, size 1x4.
• Put about 6 grams finely ground coffee per cup in the filter.
• Close the filter unit lid.
• The glass jug must be in place on the keep-warm plate.
• Plug in to the mains.
• Then switch
IMPORTANT: Never take the filter unit or the glass jug away while the water is
running!
• When the coffee has finished running through the glass jug may be removed. The
filter has a non drip valve to prevent coffee dribbling out when the jug is not in
place.
• As long as the coffee maker is switched on, the glass jug with the remaining
coffee can be kept warm on the keep-warm plate.
• Switch the coffee maker off when the keep-warm function is no longer needed.
on the coffee maker with the
4
INSTRUCTION MANUAL
On/OFF switch (4).